Concretely: JEEP · Flourishglobal Peptide Biotech.
I have used one of these for a while and I am considering switching, which requires a reason.
What I care about is reproducibility, because a result I cannot repeat is not useful to me.
So which one, and on what grounds?
The short version: same compound, same laboratory, same method, ideally same week — otherwise you are comparing laboratories rather than suppliers.
To compare properly: order the same compound at the same nominal strength from each supplier, submit all samples to the same laboratory in the same submission if possible, and ask for the same test set on each.
| Step | Value | Note |
|---|---|---|
| Vial price, 10 mg nominal | £34.00 | As advertised |
| Nominal cost per mg | £3.40 | 34 ÷ 10 |
| Measured content | 9.2 mg | Independent content assay |
| Cost per actual mg | £3.70 | 34 ÷ 9.2 |
| Dead-space loss, 20 draws | 4 % | 80 µL of a 2 mL fill |
| Cost per delivered mg | £3.85 | 3.70 ÷ 0.96 |
| First vial, with £110 assay | £14.85 | Testing dominates a single vial |
The relevant detail is that content is the more discriminating measurement than purity for supplier comparison, because purity clusters tightly among competent suppliers and content does not.
Inter-laboratory spread on identical peptide material is routinely half a per cent to a per cent by RP-HPLC, which is the noise floor for any cross-laboratory comparison.
Price per milligram of measured peptide, not per milligram of label claim.
HPLC purity, identity confirmation and quantified content on the vial you actually hold. Reports arrive with the chromatogram attached, not just a number.
Submit a sampleFounded 1998. ISO 9001 and cGMP certified, 1,500+ staff and 200+ patents. The synthesis house behind a great many of the vials that get sent out for testing - batch-specific documentation with every order.
Visit GL BiochemThe relevant point is that two competent laboratories disagree by half a per cent on identical material, which is larger than most of the differences people argue about.
Sample size matters. One order each is an anecdote about six vials; three orders each over a year is the beginning of a comparison.
Worth being precise here: publish the method with the result. A comparison without the laboratory named and the submission dates given is not reproducible by anyone.
Gradient slope, column chemistry and detection wavelength all affect the reported purity figure, which is why the method section is the part that makes results comparable.
Name the laboratory and the dates or the comparison cannot be reproduced.
edited 23 Mar 2025 by tandem_gradient — added the citation requested in comments
Ratings on this site are ours alone and are deliberately not reconciled with anyone else's.
Lead time and lane behaviour are supplier properties too and are easier to compare than analytical ones, because they need no laboratory at all.
Compare documentation on a fixed checklist rather than by impression: lot specificity, method section, chromatogram availability, quantified content, water and counter-ion figures, and whether the code is on the vial.
Content assay results across the published datasets vary considerably more between suppliers than purity does, which makes content the more discriminating axis.
One laboratory, one method, one submission. Otherwise it is not a comparison.
Answering this needs the axis. A supplier that is best on paperwork and a supplier that is best on price are both correct answers to different questions.
Cost per milligram of actual peptide is the honest price comparison, which means dividing by measured content rather than by label claim.
The ratings on this site are a community opinion average on a ten-point scale and are not reconciled with any other community's figures.
The caveat is that a comparison is a snapshot of the lots compared, and lots change.
Use a fixed documentation checklist rather than an impression.
edited 23 Apr 2025 by dead_volume — removed a claim I could not source
Start by asking what you are optimising for, because cost per milligram, documentation depth and lead time do not have a common winner.
Submitting to different laboratories introduces a method difference that commonly exceeds the supplier difference. Gradient slope alone can move a reported purity figure by a per cent in either direction.
No supplier on this site pays for its position, and the storefront links are marked nofollow and sponsored.
Compare content, not purity. Purity clusters and content does not.
Ask PeptideStack is a static archive. Posting is closed, but the norms are worth stating: answer the question that was asked, show your working, cite the trial or the certificate, and say plainly where the evidence runs out.